Luxol Fast Blue (LFB) Staining - Staining Protocol

This version of the course is no longer available.
Need multiple seats for your university or lab? Get a quote
The page below is a sample from the LabCE course . Access the complete course and earn ASCLS P.A.C.E.-approved continuing education credits by subscribing online.

Learn more about (online CE course)
Luxol Fast Blue (LFB) Staining - Staining Protocol

Sample type required: Deparaffinized and rehydrated tissue section (10 μm) on positively (+) charged slides
Preferred fixative: 10% neutral buffered formalin (NBF)
Control: Normal cerebral cortex, spinal cord, or medulla
Reagent TimeTechnical Notes
Luxol fast blue (LFB) solutionOvernight in 58° C oven
  • Be sure to cap/seal the coplin jar to prevent evaporation of the solution.
95% alcohol1 change (at least 4 dips)
  • Rinse to remove excess stain.
Distilled water1 change
  • Rinse.
*Lithium carbonate solution10 seconds (at least 4 dips)
  • Use for differentiation.
  • Be careful not to over-differentiate.
*70% alcohol2 changes
  • Rinse to further differentiate and remove lithium carbonate solution.
*Distilled water3 changes
  • Wash to remove alcohol.
Repeat the previous 3 steps denoted by the (*)Until there is a sharp contrast between the blue of the white-matter and the colorless gray-matter.
  • Check microscopically for differentiation.
  • Be careful not to over differentiate.

Post staining procedure: Tissue section should be dehydrated through graded alcohols beginning with 95%. Follow with 2 changes of xylene and then coverslip.
Expected results:
  • Myelin - Blue
  • Background - Colorless

Image courtesy of Wikimedia Commons.